Cognitive Solutions Cxi Guía de usuario descargar pdf (Pagina 208)

USING VARIABLE COMMANDS

Calibrate the Index

The following label format runs an index detector calibration routine,

and then stores the new index detector sensitivity setting in nonvolatile

RAM under index sensitivity 3. After calibration, the routine will set the

printer in index mode 3:

! 0 0 0 0

VARIABLE INDEX SETTING CALIBRATE

END

NOTE: You do not need to use VARIABLE WRITE when using the

CALIBRATE mode. CALIBRATE automatically writes its data to nonvolatile

RAM.

NOTE: The C Series printers use only the CALIBRATE parameter and not any

of the other parameters.

Setting Print Width

You can set the print width in any label format using the WIDTH

command, but if you plan to consistently use narrow print media, for

example, when using an optional wristband tray, you may want to

change the default print width. The VARIABLE WIDTH command lets

you do this.

Use the following format to change the default print width. Replace the

224 following the VARIABLE WIDTH command with the desired print

width, measured in hundredths of an inch:

! 0 0 0 0

VARIABLE WIDTH 224

VARIABLE WRITE

END

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 291 292

Sin comentarios

Cognitive Solutions Cxi Guía de usuario Pagina 208